Degreasing agents for hardening shops

CURATECH TN 133 Immersion cleaner concentrate (in powder form)

Mildly alkaline, silicate-free cleaner in powder form with high share of phosphate and wetting agent. Very well suited for degreasing after hardening and prior to tempering.

  • Cleaning and degreasing of steel components in scouring and flow-coat systems.
  • Concentration for use: 0.3 % to 1.0 %
  • Application temperature: 60 °C to 80 °C

CURATEC TN 133 is preferably used in hardening shops for the cleaning and degreasing of steel components, before and after the hardening process (oil hardening), in flow-coat process. Due to the high concentration of active substance, the product can be used very sparingly. The dosage typically is between 0.5 and 1.0 %. At these very low concentrations for use, rinsing is not necessary. The high share of special phosphates allows for the use of CURATECH TN 133 even in case of hard service water. Annoying deposits are avoided.

CURATECH SP 112 Spray cleaner concentrate (in powder form)

Mildly alkaline, silicate-free cleaner in powder form with high phosphate share and sprayable surfactants. Extremely  well suited for degreasing after hardening and prior to tempering. Rinsing is not necessary in this case. Oil-tempered parts are very well degreased and, at the same time, protected against rust.

  • Cleaning and degreasing of steel components in single chamber and multi-chamber spray systems
  • Concentration for use: 0.3 % to 1.0 %
  • Application temperature: 50 °C to 70 °C

CURATECH SP 112 is preferred used for the cleaning and degreasing of oil-tempered automat components that have adhering oil, drilling oil and shavings. In hardening shops, CURATECH SP 122 is used for the degreasing of oil-tempered steel components in single chamber and multi-chamber spray washing systems. The product features very good rust-inhibiting properties and is very well suited for the cleaning of cast iron parts, ground shafts, gear wheels, ball bearings, etc. The high share of special phosphates allows for the use of CURATECH SP 122 even in case of hard service water.

CURATECH SP 328 Spray cleaner (liquid)

Salt-free, nitrite-free neutral cleaning agent with very good organic rust protection components and foam-depressed surfactants. The product is very well suited for degreasing before and after hardening, charge nitriding, tempering, carbon nitriding in single chamber and multi-chamber spray systems. This modern spray degreaser is characterised by spotless surfaces.

  • Cleaning and degreasing of steel components in single chamber and multi-chamber spray systems
  • Concentration for use: 0.5 % to 1.0 %
  • Application temperature: 50 °C to 70 °C

The product is working foam-free from as low as 30°C. A degreasing at this temperature is sensible when the washed parts can be dried through their inherent heat.

CURATECH SP 328 may also be used when using hard service water. The active components are combined such that the oils washed off the metal surface are quickly separated out. The removal of the oil separated out takes place through a simple gravitational separator. This way, CURATECH SP 328 achieves extremely long bath service lives and is therefore extremely economical. The rust inhibitor components contained therein evaporate starting at 250°C, therefore CURATECH SP 328 is very well suited as a cleaner for thermo-chemical processes such as gas nitriding.

If you are not sure which cleaning agent would be best suited for the cleaning of your components, simply send us a description of your area of application. We are looking forward to providing you with our advice!

Copyright 2024. © PEER Energy GmbH - Webdesign Thomas HeidkampEltojada Webdesign
You are using an outdated browser. The website may not be displayed correctly. Close